When adding mains tap water pressure to the system only turn the tap 1/4 to 1/2 a turn. Use the Red Tap on the main feed into the system to  adjust the pressure to a MAXIMUM of 50 PSI ONLY

If you exceed the pressure limit of 50 PSI you will blow out the Pre Filter in your 10" Cartridge, you will know when this has occurred  because their will be Resin  on the glass. (WE DO NOT WARRANT THIS) It is clearly marked on the instructions on the back of the 2020X Window Pro System.

Flushing System,
1.Connect main hose feed
(Don't turn on tap)
2.Block pure water spout
3.Open flush tap at bottom of unit
4. Turn mains water 1/4 to 1/2 of a turn on 
5. Flush for 2 minutes
6. Run system normally for 1 minute
7. Ready to work

Use orange flush kit & turn the tap to the off position to stop water from flowing out.

For a better result and maintenance up keep on your system it is best to flush your system every 5 to 8 hours to remove any heavy particles, See guide above.

---